That is IMHO the most difficult part of the trilogy
- Navigation: rerouting options (this thread)
- Waypoint as route start / delete previous waypoints
- Import route: routing from location options
The issue in old forum here and here was with round trips, where start of navigation could guide you immediately to end, if your position is closer to end than to start.
- I would recommend that users should switch “automatic recalculation” off in round trips.
- When I am starting navigation I expect it to run without any further questions
E.g. during a fuel stop, which might be a few hundred meters away from route, I stop navigation.
When finished fueling, I start navigation again. - So if you want different behavior this could IMHO only be somewhere inside
Settings | navigation ...
Manfred