K3 is canceled when starting navigation (simulation)

Discussion App
,
1

I created this route when gambling around (not very useful, but might be interesting for developers nevertheless):

When starting navigation in simulation mode, K3 is canceled.
I have sent error feedback also, but do not know which information is transferred to developers…

canceled
canceled846×351 23.1 KB

2

That’s funny. I loaded your route and startet simulation mode also. K3 immediately stoped working.

Then I created an own route and started again. No error. It must have something to do with this specific route.

Edit: I think it’s because of your first Point. There is no route possible. That’s killing the Simulation. But you are right, it shouldn’t.

Screenshot_20230410-090711
Screenshot_20230410-0907111080×1512 91.4 KB

Regards, Nico

3

Thanks for the report, will add this to our list, I have some ideas what might be wrong here. Could even be a Simulation only issue.

4

So this is a simulation only error, I will keep this on our todo list, but simulation is not really high priority for us and this only happens with simulation active.

5

Turns out this was due to the “0m route” between start and first waypoint. The simulation engine has a bug and does not like that. It’s fixed in the next release :slight_smile:

6

Markus if you see this problem again with the simulation engine please send me the route that causes it :slight_smile:

7

Hi, I am not sure, I thought I checked it with newer version and bug was gone - but usually in that case I write a short comment (can not find any).

I just rechecked: Simulation of the route linked above works fine with current version.

Usually I do not place 2 wypoints so close together, so I just reported it because it might give a hint to an issue which might cause problems also in other situations.
But - of course - if I see such or similar behaviour again I will report.

Regards

Markus